LaPO4:Ce, Tb (G4) and (Mg, Zn)Al11O19:Eu (G2) have been widely used in tricolor phosphor lamps and PDP displays as highly effective green phosphor additives [15–18]. YVO4:Bi3+, Ln3+ (Ln = CDK inhibitor Dy, Er, Ho, Eu, and Sm) phosphors are proposed to be promising UV-absorbing

spectral converters for DSSCs as they possess broad absorption band in the whole UV region of 250 to 400 nm and could emit intense visible lights. When excited by ultraviolet light, G4 emits 550 nm of light in the green region. Considering this point, the doping of green phosphors LaPO4:Ce, Tb or (Mg, Zn)Al11O19:Eu into TiO2 photoelectrodes could lead to higher efficiency in dye-sensitized solar cells. Field emission-scanning electron microscopy (Pifithrin-�� chemical structure FE-SEM) was used to determine the morphology of this hybrid photoelectrode. The absorption and luminescence properties of dye and green phosphor ceramics were investigated using UV spectrophotometry and photoluminescence spectrometry.

Electrochemical measurements were used to Oligomycin A solubility dmso optimize the weight percentage of fluorescent materials doped in TiO2 photoelectrode, which had higher conversion efficiency (η), fill factor (FF), open-circuit voltage (V oc), and short-circuit current density (J sc) as a result. Methods Materials Anhydrous LiI, I2, poly(ethylene glycol) (mw = 20,000), nitric acid, and 4-tertiary butyl pyridine were obtained from Sigma-Aldrich (St. Louis, MO, USA), and TiO2 powder (P25) was obtained from Nippon Aerosil (EVONIK Industries AG, Hanau-Wolfgang, Germany) and used as received. Ethanol was purchased from for Daejung Chemicals & Metals Co. (Shiheung, Republic of Korea), and water molecules were removed by placing molecular sieves (3 Å) in the solvent. Commercially sourced bis(isothiocyanato)bis(2,2′-bipyridyl-4,4′-dicarboxylato)-ruthenium(II)-bis-tetrabutyl ammonium (N719 dye) and 1,2-dimethyl-3-propylimidazolium iodide were obtained from Solaronix SA (Aubonne, Switzerland). Green phosphors LaPO4:Ce,

Tb and (Mg, Zn)Al11O19:Eu were obtained from Nichia Corporation (Tokushima, Japan). The electrolyte solution consisted of 0.3 M 1,2-dimethyl-3-propylimidazolium iodide, 0.5 M LiI, 0.05 M I2, and 0.5 M 4-tert-butylpyridine in 3-methoxypropionitile. Fabrication of DSSC TiO2 powder was thoroughly dispersed for 10 h at 300 rpm using a ball mill (Planetary Mono Mill, FRITSCH, Oberstein, Germany), adding acetyl acetone, poly(ethylene glycol), and a Triton X-100 to obtain a viscous TiO2 paste. The doped green phosphors were added to the TiO2 paste and mixed in a ball mill for 2 h. The TiO2 and green phosphor-doped TiO2 pastes were coated onto fluorine-doped SnO2 conducting glass plates (FTO, 8 Ω cm−2, Pilkington, St. Helens, UK) using squeeze printing technique, followed by sintering at 450°C for 30 min.