The first group received shunt surgery using EM navigation. The second group had catheters inserted using manual method with anatomical landmark. The relationship between proximal catheter position and shunt revision rate was evaluated using postoperative STAT inhibitor computed tomography by a 3-point scale. 1) Grade I; optimal position free-floating in cerebrospinal fluid, 2) Grade II; touching choroid or ventricular wall, 3) Grade III; tip within parenchyma.\n\nResults : A total of 72 patients
were participated, 27 with EM navigated shunts and 45 with standard shunts. Grade I was found in 25 patients from group 1 and 32 patients from group 2. Only 2 patients without use of navigation belonged to grade III. Proximal obstruction took place 7% in grade 15% in grade II and 100% in
grade III. Shunt revision occurred in 11% of group 1 and 31% of group 2. Compared in terms of proximal catheter position, there was growing trend of revision rate according to increase of grade on each group. Although infection rate was similar between both groups, the result had no statistical meaning (p=0.905, chi-square test).\n\nConclusion : The use of EM navigation in routine shunt surgery can eliminate poor shunt placement resulting in a dramatic reduction in failure rates.”
“The enzymatic bioconversion of xylose into xylitol by xylose reductase (XR) is an alternative for chemical and microbiological click here processes. The partial purified XR was obtained by using the following three Caspase-8 Inhibitor procedures: an agarose column, a membrane reactor or an Amicon Ultra-15 50K Centrifugal Filter device at yields of 40%, 7% and 67%, respectively.”
“Membrane fouling can be greatly reduced by increasing the turbulence near membrane surfaces via enhancing aeration intensity or using helical baffles. A newly designed helical membrane served that purpose and achieved flux enhancement without increasing
the aeration intensity or energy consumption. In this paper, the particle image velocimetry (PIV) technique was used to demonstrate the difference in intensity and distribution of flow field/velocity vectors between the helical and the flat sheet membrane modules. The results showed that the helical membrane produced rotational flows near the membrane surface and enhanced the shearing rate/flow velocity. To further optimize the membrane geometries (dimensions and angles) and investigate the influence of membrane spacing and membrane piece numbers in a helical membrane module on its performance in filtering sludge suspensions in membrane bioreactor (MBR), various membrane modules were studied. To the single piece membrane module of different dimensions, the average flux of a helical membrane was 17-37.5% higher than that of a flat membrane. The more slender membranes had better fouling reduction and higher flux enhancement.