Hydroxy propyl methyl cellulose (HPMC), polyethylene glycol-4000 (PEG-4000), and polyvinyl pyrrolidine (PVP) (k-30) were purchased from Central Drug House Pvt. Ltd., Mumbai. Polyvinyl alcohol (PVA) was purchased from SD fine Chemicals Ltd., Mumbai. Aceclofenac microcrystals were prepared using anti-solvent precipitation technique. 11.6 g of drug was

weighed and it was dissolved in 50 ml of acetone. This solution was added to the aqueous Selleckchem Hydroxychloroquine phase i.e., 0.5% w/v solution of hydrophilic stabilizing agents [PVP (k-30), PVA, PEG-4000 and HPMC] under constant stirring and the stirring was continued for 1 h. The resultant dispersion was filtered using Whatman filter paper and the microcrystals formed were separated. The microcrystals obtained were dried for 48 h under room temperature.6 FT-IR studies were conducted using FT-IR spectrophotometer (Model NP-602378-14,002, instrument serial No. 72425). The spectrum was recorded in the region of 4000–400 cm−1. The method opted was potassium bromide pellet technique. click here Particle size of the microcrystals was determined using optical microscopy. The microscope was calibrated

using an eyepiece and a stage micrometer and then used for the particle size determination. 100 microcrystals were measured for their size individually. From the values obtained, the average particle size of the microcrystals was determined. 100 mg of the formed microcrystals were taken in a standard flask containing 20 ml of distilled water. The samples were shaken at room temperature for 48 h and then they were filtered. The filtrate was diluted suitably and then analyzed using UV spectrophotometer at 275 nm. 100 mg of the prepared microcrystals was weighed and taken into a 100 ml standard flask. The volume was made using pH 6.8 phosphate buffer. Then Linifanib (ABT-869) it was sonicated for 10 min. The resultant solution was diluted suitably and then analyzed using UV spectrophotometer at 275 nm. The drug and the microcrystals were studied for various flow properties like bulk density, tapped density, Hausner ratio and Carr’s index. In-vitro dissolution studies were carried out using

USP type II dissolution apparatus. The release of aceclofenac from the prepared microcrystals was studied using phosphate buffer pH 6.8 as the dissolution medium. 100 mg of the microcrystals were added to 900 ml of the dissolution medium. Dissolution medium was maintained at 37 ± 0.5 °C temperature and the paddle was rotated at 75 rpm. After suitable time intervals, 10 ml of samples were removed and 10 ml of fresh dissolution media was added to maintain the sink conditions. The withdrawn samples were analyzed using UV–Visible Spectrophotometer at 275 nm. The drug content was found to be good and uniform among the different batches of the prepared samples and ranging from 87.5% to 97.75% (Table 1). The microcrystals prepared with PVP (k-30) showed better drug content when compared to other formulations. The IR spectrum of the untreated drug (Fig.