All authors have none to declare. “
“Amorphous forms are low-density solids having larger free volume, which exhibit higher internal energy and increased molecular mobility that can yield transient dissolution rate considerably greater than does its thermodynamically stable crystalline form.1 However molecular hydrophobicity and inherent lattice forces greatly influences improvement in solubility by way of amorphisation of a drug substance. Also recrystallisation of metastable amorphous state of a drug substance
may be expected during storage because of its inherent structural and thermodynamic properties. Hence amorphous form of such drug substances were stabilised by coprocessing it with polymers by utilising complexation,2 and 3 rapid sublimation,3 and 4 rapid solvent evaporation5 and rapid LY2109761 price solidification6 and 7 approaches. For drug molecules such as Acetazolamide,8 which have low molecular lipophilicity (log P: 0.14) and a high melting point (∼260 °C) it is likely that disruption of the lattice forces and its molecular dispersion within hydrophilic carrier matrix would effectively enhance its solubility properties.1 Hot melt extrusion technique has established its place in the range of pharmaceutical manufacturing technologies in the preparation of solid dispersions of active
pharmaceutical ingredients. Formation of completely amorphous SB431542 molecular weight solid solutions by such rapid solidification techniques necessitates heating the materials to temperature higher than the melting point of the higher melting component of the blend to ensure marked rise in solubility. Hence formulation of solid dispersions of poorly soluble drugs like Acetazolamide showing melting at high temperature accompanied by thermal degradation, with polymer undergoing degradation at such elevated temperatures and pressures becomes a major challenge. Use of appropriate plasticisers in optimised proportion lowers the processing
temperature needed to melt drug–polymer blend7; thereby minimising potential degradation and/or browning of the extruded product and augments drug stability in Adenylyl cyclase pharmaceutical formulations.9 Extrusion process is also facilitated by the lowered melt viscosity by addition of the plasticisers.9 Thus, the present study interestingly explores utilisation of hot melt extrusion technique for formulating amorphous molecular dispersions of poorly soluble drugs having thermosensitive nature, which was not emphasised in a collective manner in the previous studies. Acetazolamide (denoted as ACT) was supplied as a gift sample from D. K. Pharma Chem Pvt. Ltd. (Mumbai, India). Eudragit® EPO (denoted as EPO) and Lutrol® F-87 (denoted as POL) were kindly gifted by Evonik Degussa India Pvt. Ltd. (Mumbai, India) and BASF Corporation (Washington, USA), respectively.